| Command | Description |
|---|---|
| access-enable | Create a temporary Access-List entry |
| access-profile | Apply user-profile to interface |
| access-template | Create a temporary Access-List entry |
| bfe | For manual emergency modes setting |
| cd | Change current directory |
| clear | Reset functions |
| clock | Manage the system clock |
| configure | Enter configuration mode |
| connect | Open a terminal connection |
| copy | Copy from one file to another |
| debug | Debugging functions (see also 'undebug') |
| delete | Delete a file |
| dir | List files on a filesystem |
| disable | Turn off privileged commands |
| disconnect | Disconnect an existing network connection |
| enable | Turn on privileged commands |
| erase | Erase a filesystem |
| exit | Exit from the EXEC |
| help | Description of the interactive help system |
| lock | Lock the terminal |
| login | Log in as a particular user |
| logout | Exit from the EXEC |
| more | Display the contents of a file |
| name-connection | Name an existing network connection |
| no | Disable debugging functions |
| pad | Open a X.29 PAD connection |
| ping | Send echo messages |
| ppp | Start IETF Point-to-Point Protocol (PPP) |
| pwd | Display current working directory |
| reload | Halt and perform a cold restart |
| resume | Resume an active network connection |
| rlogin | Open an rlogin connection |
| rsh | Execute a remote command |
| send | Send a message to other tty lines |
| set | Set system parameter (not config) |
| setup | Run the SETUP command facility |
| show | Show running system information |
| slip | Start Serial-line IP (SLIP) |
| start-chat | Start a chat-script on a line |
| systat | Display information about terminal lines |
| telnet | Open a telnet connection |
| terminal | Set terminal line parameters |
| test | Test subsystems, memory, and interfaces |
| traceroute | Trace route to destination |
| tunnel | Open a tunnel connection |
| undebug | Disable debugging functions (see also 'debug') |
| verify | Verify a file |
| where | List active connections |
| write | Write running configuration to memory, network, or terminal |
| x28 | Become an X.28 PAD |
| x3 | Set X.3 parameters on PAD |