| Command | Description |
|---|---|
| access-expression | Build a bridge boolean access expression |
| arp | Set arp type (arpa, probe, snap) or timeout |
| backup | Modify backup parameters |
| bandwidth | Set bandwidth informational parameter |
| bridge-group | Transparent bridging interface parameters |
| carrier-delay | Specify delay for interface transitions |
| cdp | CDP interface subcommands |
| cmns | OSI CMNS |
| custom-queue-list | Assign a custom queue list to an interface |
| default | Set a command to its defaults |
| delay | Specify interface throughput delay |
| description | Interface specific description |
| exit | Exit from interface configuration mode |
| fair-queue | Enable Fair Queuing on an Interface |
| help | Description of the interactive help system |
| hold-queue | Set hold queue depth |
| ip | Interface Internet Protocol config commands |
| keepalive | Enable keepalive |
| llc2 | LLC2 Interface Subcommands |
| load-interval | Specify interval for load calculation for an interface |
| logging | Configure logging for interface |
| loopback | Configure internal loopback on an interface |
| mac-address | Manually set interface MAC address |
| media-type | Interface media type |
| mtu | Set the interface Maximum Transmission Unit (MTU) |
| netbios | Use a defined NETBIOS access list or enable name-caching |
| no | Negate a command or set its defaults |
| priority-group | Assign a priority group to an interface |
| random-detect | Enable Weighted Random Early Detection (WRED) on an Interface |
| shutdown | Shutdown the selected interface |
| snapshot | Configure snapshot support on the interface |
| snmp | Modify SNMP interface parameters |
| standby | Hot standby interface subcommands |
| timeout | Define timeout values for this interface |
| traffic-shape | Enable Traffic Shaping on an Interface or Sub-Interface |
| transmit-interface | Assign a transmit interface to a receive-only interface |
| tx-queue-limit | Configure card level transmit queue limit |