Switch#setup
--- System Configuration Dialog ---
At any point you may enter a question mark '?' for help.
Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
Continue with configuration dialog? [yes/no]: yes
Enter IP address: 192.168.0.5
Enter IP netmask: 255.255.255.0
Would you like to enter a default gateway address? [yes]: yes
IP address of default gateway: 192.168.0.2
Enter host name [Switch]:
The enable secret is a one-way cryptographic secret used
instead of the enable password when it exists.
Enter enable secret: password
Would you like to configure a Telnet password? [yes]: yes
Enter Telnet password: password
Would you like to enable as a cluster command switch? [yes/no]: no
The following configuration command script was created:
ip subnet-zero
interface VLAN1
ip address 192.168.0.5 255.255.255.0
ip default-gateway 192.168.0.2
enable secret 5 $1$56r9$UgWc4/Nz6Z8cP.lZS9nVj.
line vty 0 15
password xeon
snmp community private rw
snmp community public ro
!
end
Use this configuration? [yes/no]: yes
The enable secret you have chosen is the same as your enable password.
This is not recommended. Re-enter the enable secret.
Building configuration...
Use the enabled mode 'configure' command to modify this configuration.
Press RETURN to get started.
Switch#